Turning PC On with a Knock Using ATtiny45 and a Piezoelectric Sensor

PS/2 with ATtiny45

Today’s post is something I’ve prepared for a long time. Hardware-wise it’s a simple thing – ATtiny45 emulating a PS/2 device, sending a keypress when three knocks are detected in the attached piezoelectric sensor (or piezo buzzer as they are also called). But if your computer can boot on PS/2 keyboard input and you have your computer stowed somewhere hard to reach (or just want to impress your friends), it’s a pretty neat little gadget! Here’s a video of it in action:

My PC takes a few seconds to put anything on display, but if you look at the bottom right corner, you can see the blue power LEDs light up immediately after the knocks.

What You’ll Need

Hardware-wise this hack is super simple. You’ll need less than $10 in parts and many probably already have these lying around:

  • ATtiny45. Actually, any ATtiny or ATmega with 4kB or more flash, A/D converter and two timers will work with small adjustments, and with -Os -DMINIMAL compiler flags also 2kB MCUs (ATtiny2313 doesn’t have a A/D but you can either work around it or use a button)
  • Piezo buzzer and 1 Mohm resistor to act as knock sensor
  • PS/2 connector, or alternatively a passive USB-PS/2 adapter (I have half a dozen from old keyboards and mice) and USB cable (like the one I used in my V-USB tutorial)
  • Breadboard and wire. Alternatively you can solder it on a simple PCB like I eventually did.
  • Optionally, a 4k7 ohm pullup resistor for RESET line, and a LED and 330 ohm resistor to indicate state

The Schematic and Breadboard Setup


The PS/2 part as discussed in my minimal PS/2 keyboard post doesn’t require any other hardware than the ATtiny. The piezo element uses a 1 Mohm resistor like in the Arduino Knock Sensor tutorial, providing a path for voltage level to get back to zero over time. The LED is connected to PB4.

The PS/2 connector also provides power to the device. Instead of soldering a custom PS/2 connector for the project, I took a passive USB-PS/2 adapter I had lying around and used a multimeter to find out which USB pins correspond to the PS/2 ones. Not surprisingly, PS/2 GND and VCC are connected to USB GND and VCC. In my adapters, PS/2 clock was connected to D+ and data to D-. You can see the mnemonic printout I made on that one below, as well as one possible breadboard configuration.
Continue reading Turning PC On with a Knock Using ATtiny45 and a Piezoelectric Sensor

AVRweb 0.1 alpha released

After several months of sporadic coding, I finally got this large project to a point where I can consider making the first alpha release. So without further ado, I present AVRweb, a web-based UI for programming AVR chips.

Basically, it is a self-contained web server that allows you to interface with avrdude to read fuse settings, change them, and in the future, much more. The first alpha release is centered around fuse settings, and should already make the changing of AVR fuse bits a much quicker task – current settings are automatically read from the connected device, so you don’t need to toggle switches anymore to find the current setup. Also, new settings can be changed with a press of a button. See the video demonstration below (note that I’m running AVRweb on a PC, and just using the web interface with iPad, it’s not an iPad application!):

Continue reading AVRweb 0.1 alpha released