Stellaris Launchpad PWM Tutorial

After receiving my Stellaris Launchpad, I decided to browse the little amount of tutorials there was available on the subject. I was really impressed by the Getting Started hands-on workshop offered in TI’s wiki. After watching the first few tutorials, I had a somewhat firmer grasp on how this little puppy was supposed to be programmed, and the capabilities of the Code Composer Studio IDE.

I got as far as Chapter 4: Interrupts until I hit the first snag: After the Lab4 assignment, the friendly instructor told that as a home assignment, one could try out the PWM (pulse-width modulation) capabilities of the Launchpad before proceeding further. Little did I know how many hours I would spend on that topic! After a solid 8 hours of banging my head against the documentation, Launchpad and CCS (which is prone to hanging at least on my PC), I finally got it working, and decided this would be a great place for a tutorial.

Rule 1 of PWM on Launchpad: There are no PWM units

The initial four hours of my PWM efforts were spent on the StellarisWare Driverlib documentation concerning PWM. In case you haven’t yet watched the tutorials, the Driverlib is essentially a bundle of code that takes away the burden of writing into dozens of control registers, and instead presents the programmer with a couple of hundred API calls to enable a higher-level approach.

It wasn’t until the third hour of googling around that I discovered, that while the timer functionality of the Launchpad includes a PWM mode, there are no actual PWM units on board! So if you’re looking at the PWM functions in Chapter 21 of Stellaris Peripheral Driver Library User’s Guide – stop it and get back to the Chapter 27: Timer functions.

Step 1: Setting up the timer0 PWM mode

So the only PWM functionality the Launchpad supports is the “PWM mode” of the six hardware timers. Thankfully, that’s already quite nice (if I ever find out how to use interrupts with PWM, even better). So unless you already know how the timer system works, now’s a good time to watch the Chapter 4 video which explains it quite nicely. Based on that tutorial, we learn that the following piece of code should initialize the timer for us:

SysCtlPeripheralEnable(SYSCTL_PERIPH_TIMER0);
TimerConfigure(TIMER0_BASE, TIMER_CFG_PERIODIC);

ulPeriod = (SysCtlClockGet() / 10) / 2;
TimerLoadSet(TIMER0_BASE, TIMER_A, ulPeriod - 1);

TimerEnable(TIMER0_BASE, TIMER_A);

Continue reading Stellaris Launchpad PWM Tutorial