8 bit and 4 bit LCD interfacing with ATtiny

Since my brief journey to controlling LCD display directly with ATtiny2313 I purchased a display with Hitachi HD44780 compatible driver chip. The web is already pretty full of LCD tutorials and libraries, but most seemed to either skip details and rely on external libraries, or were just overly complex. So I decided it wouldn’t hurt to share the rather short (and functionally limited) versions I came up with.

8-bit mode

In 8-bit mode, you will be needing 8 pins for sending or reading a whole byte of data at once, and 3 control lines: enable (EN), register select (RS), and read/write (RW). Basic procedure is to prepare all other lines, and then pulse the enable line high for a short while in which LCD reads your command (when RW is low) or writes data (when RW is high). For control messages, RS line is low, and for writing letters, RS line is high.

I started with ATtiny2313 and used the 8 pins in port B as LCD data lines, and PD4, PD5, and PD6 as RW, RS, and EN, respectively. With such a setup, working write command became:
Continue reading

Driving an LCD display directly with ATtiny

My local electronics shop Partco (arguably the best in Finland) had a great offer on 6-digit LCD displays. For 1€ a piece, I immediately bought one:

Once I had my hands on it, the reason for such a low price became apparent: There was no controller chip, only 50 pins and the knowledge that pin 1 was “common cathode” and the rest were for the segments. So I decided to see if I could get it work directly without a controller. And succeeded, read on to learn how!
Continue reading